The ProOne G2.0 filter cartridges are easy to install, use and clean. Priming is not required, and no additional filters are needed to remove fluoride.
Installation
Follow the step-by-step guide below:
- 1. Take the filter element and fit the rubber ring onto the shaft.
- 2. Insert the handle through a hole in the top tray.
- 3. Screw the wing nut onto the underside of the top housing. Once you feel resistance, it is tight enough. PLEASE NOTE! Do not overtighten it. Repeat steps 1 and 2 for any other filter elements.
- 4. Seal the remaining holes with the plugs supplied.
- 5. Place the top container on top of the bottom container.
- 6. Fill the top tank with water and let the water run through. We recommend discarding the first two cycles!