ProOne ProMax Shower Filter Replacement Cartridge

ProOne ProMax Shower Filter Replacement Cartridge – Suitable only for ProOne ProMax shower filters.

The ProOne ProMax Shower Filter replacement cartridge features highly efficient multi-stage water filtration technology. Each stage consists of a unique, patented formula of infused microporous foam™ disc media, designed to tackle a specific group of contaminants. Contains no resins or beads. Designed for unrivalled performance and maximum reduction of contaminants. Independent laboratory report shows that the ProOne ProMax Shower Filter replacement filter reduces or removes a wide range of over 200 contaminants, including VOCs, lead, fluoride, chlorine, chloramines, heavy metals, pesticides, SVOCs, disinfectants, inorganic non-metals, herbicides, pharmaceuticals, PFOA, PFOS and microorganisms. Tested in accordance with NSF/ANSI standards 42 and 53.

A summary of the ProOne ProMax shower filter replacement cartridge:

• Suitable for the ProOne ProMax shower filter and ProOne ProMax shower filter with shower head
• 4-stage filtration process
• Removes more than 200 contaminants, including fluoride
• Helps to keep limescale, algae and bacteria under control
• See ‘independent’ lab report, tested in accordance with NSF/ANSI 42 and 53 standards
• Easy to replace
• Filter life of up to 9 months
• No carbon residues
• Takes just 15 seconds to rinse through before use

Installation instructions for the ProOne ProMax shower filter replacement cartridge:

1. Unscrew the shower filter from the tap or shower arm by turning it anti-clockwise
2. Unscrew the casings from one another by turning the top and bottom in opposite directions
3. Remove the replacement filter. Ensure that the O-rings remain in the correct grooves within the filter housings. The upper housing holds 2 O-rings. The lower housing holds 1 O-ring.
4. Fit the new replacement filter. PLEASE NOTE: The side of the replacement filter with the mesh is the top!
5. Tighten the casings back on
6. Replace the Teflon tape on the tap or shower arm and reattach the shower filter to the tap or shower arm, tightening it clockwise (PLEASE NOTE!! Do NOT overtighten it)
7. Let the water run for 15 seconds without standing under it yourself
7. You’re all set again and can enjoy the ProOne ProMax shower filter once more

Comments:
– If there is a leak between the two housings after replacing the filter, try tightening them further. If this does not help, loosen the housings and check that the O-ring is sitting correctly in the groove. If necessary, you can turn the O-ring round. Then tighten the housings securely again and test once more. Keep repeating these steps until the leak has stopped.
– Replace the filter every 6 to 9 months.