The Coldstream FTO PLUS filter elements are easy to install, use, and clean. Priming is not necessary, and no additional filters are required to remove fluoride. Before installing, simply rinse the outside briefly under cold running water and, if necessary, scrub it lightly with a scouring pad to remove any manufacturing residue.
Installation
Follow the step-by-step guide below:
- 1. Pick up the filter element and place the rubber ring on the stem.
- 2. Insert the stem through a hole in the top container.
- 3. Screw the wing nut onto the bottom of the top housing. When you feel resistance, it’s tight enough. CAUTION! Do not overtighten. Repeat steps 1 and 2 for any other filter elements.
- 4. Seal any remaining holes with plug caps.
- 5. Place the top container on top of the bottom container.
- 6. Fill the top tank with water and let the water run through. We recommend discarding the first two cycles!
You can also refer to the user manual at any time; see the Coldstream FTO PLUS Filter User Manuals for more information.