How do I install the ProOne G2.0 filter elements?

The ProOne G2.0 filter elements are easy to install, use and clean. Priming is not required and no additional filters are needed to remove fluoride.

Installation
Follow the roadmap below:

• 1. Take the filter element and place rubber ring on the stem.
• 2. Insert the handle through a hole in the top tray.
• 3. Tighten the wing nut on the underside of the upper tray. If you feel resistance, that is enough. Do not overtighten. Repeat steps 1 and 2 for any other filter elements.
• 4. Seal the remaining holes with the blocker plugs provided.
• 5. Place the upper tray on top of the lower tray.
• 6. Fill the upper container with water and allow the water to drain. We recommend discarding the first 2 cycles!