Sometimes, after cleaning, the appliance may not produce a white mist, or
is not bubbling slightly. In such cases, the electrolytic plate usually does not make good contact with the
electrolysis plate because the wing nuts have not been tightened back on completely straight. This is sometimes
Just give it a few go, but it always works in the end. After a few attempts, you’ll see that it
the device is working as normal again.
So, if you do not see any air bubbles (fizzing or bubbling) coming out of your AquaPure, switch the unit off and remove it from the water. Turn the top cover anti-clockwise to the unlocked position by turning the lever. Once the top cover has been removed, turn the nuts on the inner electrolyte components clockwise to tighten them. This should resolve the problem immediately.
If that still doesn’t work, please check that the small grid inside is positioned correctly. You can tell this by the two indentations on one side of the grid, next to a hole. These fit exactly onto the two protrusions on the appliance, on one side near the electrode. See also the image below:
